driveway and concrete protector
driveway and concrete protector

Ez Shield

$45.00 $35.00

Actual Area (sq. ft.) 300

Ez-Shield is a colorless, non-flammable surface treatment that produces an invisible protective coating on stone, concrete, unglazed tile and marble that is water and oil repellent.

Data Sheet sdsbutton
COVERAGE RATE 300-400 square feet per gallon
DRY TIME 8-10 hours
TYPE Water based silane/siloxane shield
ODOR Very Low
TOXICITY Non-toxic
VOCS 0 gm/L
FLAMMABILITY Non-flammable
COMPOSITION Silane/siloxane solution

Ez Shield can be applied to vertical or horizontal surfaces by brush, roller or low pressure sprayer.


  1. Apply to wet the surface completely. 300 to 400 sq.ft per gallon.
  2. Ez Shield if ready to use and should not be diluted.
  3. Avoid application in windy weather. In hot weather where possible lightly spray surface with water to cool the surface to prevent flash drying. Ez Shield is best applied by low-pressure airless sprayer but can be applied by garden-type sprayer or small areas can be applied by brush or roller.
    • For airless spray use a small to medium size airless pump, set at low pressure (500 psi) and a large .035” to .050” tip. Hold spray tip 12-18 inches from the surface and work from the bottom up with an overlapping horizontal spray pattern to ensure run down.
  4. Take special care to saturate mortar joints.
  5. Do not stop or interrupt the application in the middle of the wall. Stop application only at expansion joints, walls or breaks defined with masking tape

Additional information

Weight 13 lbs
Dimensions 6 x 6 x 13 in


There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.