U PREP IT ™- GLUE AND PAINT REMOVAL KIT

This Concrete Floor Prep kit is used prior to sealers and epoxy coatings. This method should be used when there are glues and light paints present.

Step 1: 

  • Spray a liberal amount of Pine Stripper on the floor and allow it to dwell. 
  • Scrape the floor using a scraping tool to remove as much topical glue and/or paint as possible. 
  • FLOOR COMPLETION AFTER STEP 1

    0%

Step 2: 

  • Completely wet the floor with water. 
  • Use a black pad on the floor underneath a low speed buffer, propane burnisher or auto scrubber. 
  • Squeegee and wet vac dirty water from the floor before it dries. 
    • Try and get up as much of the contaminate as possible with the black pad. 
    • Spot treat any areas with Pine Stripper that are troublesome before running the Concrete DNA™ Diamond Satellite Pad
  • Switch to the (30 grit) Concrete DNA™ Diamond Satellite Pad and repeat the following: 
    • Completely Wet the Floor
    • Use the Concrete DNA™ Diamond Satellite Pad underneath a low speed buffer, propane burnisher or auto scrubber. 
    • Squeegee and wet vac dirty water from the floor before it dries. 
  • FLOOR COMPLETION AFTER STEP 2

    0%

Step 3: 

  • Run the red pad with plenty of water mixed with the diluted Ez Clean to clean and lift the remaining dirty from the floor. 
  • Squeegee and Vac dirty water from the floor before it dries. 
    • Let your floor dry the necessary amount of time before applying you sealer or coating. 
  • U PREP IT ™- GLUE AND LIGHT PAINT REMOVAL COMPLETED

    0%

Uses

Retail Stores

Lofts

Restaurants

Warehouse Floors

Office Spaces

Concourses

Basement Floors

Highlights

Durable Finish

Cost Efficient

Easy to Clean and Maintain

Will not chip or peel

Product Sheets

Strip It

Ez Clean